Table of Contents
Advertisement
No.
Part name
1. Detachment
7
Fan guard
1) Perform work of procedure 1 -1.
2) Take off screws and clamp fixing the fan guard.
NOTE)
The specification of fixing screws for the fan guard
differs from those of other fixing screws.
Therefore keep them separately from other screws.
2. Attachment
1) Attach screws and clamp for fixing the fan guard.
1. Detachment
8
Bell mouth
1) Perform work of procedure 6 -1.
2) Take off the lead wires of the drain pump, float
3) Take off fixing screws of the bell mouth.
2. Attachment
1) Mount the bell mouth with screws.
2) Perform wiring as original before being
NOTE)
Pinch lead wire of the drain pump and float switch
with lead wire fixing claws of the bell mouth and
perform wiring along the guide.
9
1. Detachment
Turbo fan
1) Perform work of procedure 8 -1.
2) Take off the nut (M6 nut 1 pc.) of the turbo fan.
NOTE)
Use a box wrench for attachment and detachment of
the turbo fan. If using a monkey wrench etc, the other
parts may be damaged in work.
2. Attachment
1) Insert the turbo fan into the fan motor so that
NOTE)
Tightening torque of turbo fan: 4.4 ± ft . lbs(5.9 ±
0.6Nm)
Apply looseness-preventing agent to the nut after
tightening.
Procedure
(Ø4 × 0.39"(10mm), [Screws for plastic
molding] 3 pcs.))
(Ø4 × 0.39"(10mm), [Screws for plastic
molding] 4 pcs.))
switch, and fan motor from the bell mouth.
(Ø4 × 0.31"(8mm), 4 pcs.))
(Ø4 × 0.31"(8mm), 4 pcs.))
removed.
boss of the turbo fan matches with cut surface
of the fan motor, and then tighten it with nut.
Fan motor fixing
M6 nut
Turbo fan
118
Remarks
Clamp
Fan guard
4 screws
Fixing claws
for lead wires
Bell mouth
4 screws
Fixing claws
for lead wires
Drawing-out port of
fan motor lead wire
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
