Using An Sd Card; Usable Sd Cards; Inserting An Sd Card; Removing An Sd Memory Card - Sony PMW-F55 Operating Instructions Manual
Solid-state memory camcorder
Hide thumbs
Also See for PMW-F55:
- Operating instructions manual (134 pages) ,
- User manual (68 pages) ,
- Manual (60 pages)
Table of Contents
Advertisement
When restoration is completed, the completion
message is displayed, then press the MENU dial
to disappear the message.
If restoration fails
• A write-protected SxS memory card, or one on
which an error occurred, cannot be restored. For
such a card, a warning message is displayed.
Release the write protection or replace the card,
according to the instructions in the message.
• An SxS memory card on which an error
occurred may become usable again through
repeated formatting.
• In some cases, only parts of clips cannot be
restored. Playback of the restored clips becomes
possible again.
• The following operation may restore an SxS
memory card for which the message "Could not
Restore Some Clips" is repeatedly displayed
each time you try the restoration process:
1
Copy necessary clips to another SxS memory
card, using the dedicated application
software (page 106).
2
Format the problem SxS memory card, using
the format function of this camcorder.
3
Copy the clips back to the SxS memory card.
Recording/playback during restoration
You can perform recording or playback using the
SxS memory card in the other card slot while
restoration is in progress.
Note
For restoration of media recorded with this unit, be sure
to use this unit. Media recorded with a device other than
this unit or with another unit of different version (even of
the same model) may not be restored using this unit.
To update the managerial file
If clips cannot be played back, updating the
managerial file on the card may improve the
situation. For this operation, use "Update Media"
(page 78) of the Media menu.
If you write an XAVC file that is imported by
RAW Viewer V2.2 or later to the
"XDROOT\Clip" directory of an SxS memory
card directly, that file can be played by
performing "Update Media."
30
Using an SD Card
Using an SD Card
You can store the setting value file of the camera
on an SD card (optional). The stored file can be
loaded from the SD card.
Usable SD Cards
SDHC memory card* (Speed Class: 4 to 10,
UHS is not compatible, Capacity: 2 GB to 32 GB)
SD memory card* (File system: FAT 16,
Capacity: up to 2 GB)
* Indicated as "SD card" in these Operating Instructions.
Inserting an SD Card
1
Open the cover of the card slot block
(page 13).
2
Insert the SD memory card into the slot
with the SD label facing up.
The ACCESS lamp (page 13) lights in red
then changes to green once the memory card
is ready for use.
3
Close the cover.
Status indications by the ACCESS lamp
Lamp
Slot statuses
Lights in
Accessing the SD card (writing/reading
red
data)
Off
• No SD card is loaded.
• The loaded card is invalid.
Removing an SD memory card
Open the cover of the card slot block,
remove the SD card by pressing the SD card
once lightly.
Notes
• Data integrity is not guaranteed if the power is turned
off or a memory card is removed while it is being
accessed. Data on the card may be destroyed. Be sure
that its ACCESS lamp is lit in green or off when you
turn off the power or remove a memory card.
• Make sure that the card does not pop out when
inserting or removing it.
- Quick Links:
- Shooting Mode
- Camera Menu
Hide quick links:
Advertisement
Table of Contents
