Brother DCP-8070D Service Manual page 388

Laser fax/mfc

Hide thumbs Also See for DCP-8070D:

Table of Contents

(2) Lift up the CCD Module and Guide shaft and pull the Guide shaft out of the CCD Module.

(3) Remove the Belt support rubber, and then remove the Belt from the CCD module.

(4) Remove the double-faced adhesive tape which is attached between the FFC cable and

CCD module, and disconnect the FFC cable from the CCD module.

• After disconnecting flat cable(s), check that each cable is not damaged at its end or

short-circuited.

• When connecting flat cable(s), do not insert them at an angle. After insertion, check

that the cables are not at an angle.

Belt support rubber

Scanner base

Confidential

Show Quick Links

Chapters

Table of Contents