F-4 Installing Windows 2000
INSTALLING WINDOWS 2000
Preparations for Installation
NEC EXPRESSBUILDER CD-ROM
Microsoft Windows 2000 Server (CD-ROM)
Windows 2000 Service Pack (CD-ROM)
User's Guide
Getting Started
Windows 2000 Clean Installation
This section explains how to perform a clean installation of Windows 2000.
1.
Turn on the system power.
2.
Insert the Windows 2000 CD-ROM into the DVD-ROM drive.
3.
Press Ctrl + Alt + Delete to reset the system.
After a bootable operating system has been installed on the hard disk drive, press Enter
while the message "Press any key to boot from CD..." is displayed at the top of the screen.
If no bootable operating system exists on the hard disk drive, this step is unnecessary.
The Windows 2000 setup screen will appear.
If the screen is not displayed, Enter was not pressed properly.
Begin after turning on the system power again.
4.
If the RAID controller is installed in the system, press F6 in a few seconds when the
window is in either of the following states.
– "Setup is inspecting your computer's hardware configuration ..." is displayed.
– A screen with a solid blue background is displayed.
IMPORTANT:
been pressed.
There is no visible indication on screen when F6 has