GB 14
4.
4.2.8
Accessing the Side I/O panel
Figure 4-10
4.2.9
Accessing the Mains Switch panel
1
2
3
Figure 4-11
The easiest way to access this module is with the LSP in
service position 2.
1. Release the two fixation clamps by pulling them
backward [1].
2. At the same time, the complete assy must be pulled
backward [2].
3. If the board has to be removed, release the 2 clamps at
the bracket sides and lift panel up [3].
4.3
Mounting the Rear Cover
Before mounting the Rear Cover, some checks has to be
performed:
•
Check whether the Mains Cord is mounted correctly in
the guiding brackets.
•
Check whether all cables are replaced in their original
position. This is very important due to the large 'hot' area
of the set.
EM1A
Mechanical instructions
CL 06532012_004.eps
030200
1
3
CL 06532130_018.eps
021000
1. The complete Side I/O-assembly can easily be removed
by unscrewing the 2 fixation screws.
2. The board can easily be lifted out of the bracket after
releasing the 2 fixation clamps.