Whirlpool Electric Dryer Use And Care Manual page 18
Electric and gas dryers
Hide thumbs
Also See for Electric Dryer:
- Installation instructions manual (7 pages) ,
- Installation instructions (5 pages) ,
- Use and care manual (28 pages)
Advertisement
REMOVING
ACCUMUlAlED
UNT FROM INSIDE ME DRYER
CABINET~UNK,
7. Remove 2 internal screws from front panel
flanges (near top front corners). Lift front panel
slightly, lifting off lower clips (see lower clip
inset of illustration
below). Slowly pull front
panel forward, disengaging
panel from drum.
(Drum will drop slightly.)
8.
Move front panel aside and rest edge against
side of dryer. Avoid disconnecting
wire clips
(see wire clips inset of illustration
below) or
damaging wires.
9. Remove any lint using a vacuum cleaner or
soft brush.
Burner
(gas models only)
Motor
Dryer with front panel removed
10.
Reassemble in reverse order. Before closing
the top, check the following:
- Drum seal must be flared out (see drum seal
insets of illustration)
and properly positioned
against panel at back of drum. Rotate drum
counterclockwise
one full turn to check
drum seal.
- Belt should be centered and tight on
dryer drum.
- Wire clip retainer, which holds the door
switch wires, must be secured to top of front
panel (see wire clips inset of illustration) and
along top edge of side panel. Door wires
must not touch drum when dryer is
operating.
11.
Replace top panel and lint screen screws. Top
and front panels must be securely in place
before operating dryer.
12.
Level the dryer if necessary.
13. Plug in dryer or turn on power supply.
18
Advertisement
