Ventilation, Coa Label, And Serial Number Label Information - HP xw series Setup And Troubleshooting Manual

Workstations

Hide thumbs Also See for xw series:

Setup and troubleshooting manual (40 pages)

Troubleshooting manual (52 pages)

Installation manual (20 pages)

Table Of Contents

Table of Contents

To rapidly set up your workstation hardware, complete the following steps:

After unpacking your HP Workstation, locate an accessible workspace to set up the system and

connect the mouse, keyboard, and power cables to your workstation. Connect the power cable

from the workstation to a power outlet.

Connect the workstation monitors, as appropriate for your system configuration, as follows:

●

If your workstation has a PCI-Express graphics card with a DMS-59 output receptacle (see

Table 2–2), use an appropriate adapter to connect your monitors. Adapters are available to

connect the DMS-59 output to two DVI or two VGA monitors. Figure 2–1 (lower inset)

illustrates using an adapter to connect dual DVI or VGA monitors to the workstation DMS-59

output.

●

If your workstation has a PCI-Express graphics card with two DVI output receptacles (see

Table 2–2), you can connect a monitor to each DVI receptacle (using appropriate adapters,

if required).

NOTE:

BIOS and other important information) will be port #1; defined as the port physically closest

to the system board, and located on the PCI-Express card bulkhead installed closest to the

workstation chassis rear panel.

●

If your workstation does not have a PCI-Express graphics card, but, alternatively, has an

SVGA (see Table 2–2) and a DVI-D output receptacle located on the workstation chassis rear

panel, you can connect a monitor to each output.

Connect a power cable from each monitor to a power outlet, as shown in Figure 2–1.