Table of Contents
Advertisement
Power Switch/LED Assembly
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Lay the computer on its side with the front facing toward you.
4.
Remove the front bezel
5.
Remove the optical drive
6.
Remove the hard drive
7.
Disconnect the cable from the black system board connector.
8.
Remove the cable from the clips under the hard drive cage.
Figure 5-13
9.
Press the tab (1) on the bottom of the power switch to disengage it from the chassis, slide the
switch downward to disengage the tabs from the chassis (2), and then pull the power switch
away from the chassis while guiding the wires through the hole in the chassis.
Figure 5-14
10.
Remove the power switch cable from the clips located in the optical drive bay on the inside of the
chassis.
To install the power switch/LED assembly, reverse the removal procedures.
(Access Panel on page
(Front Bezel on page
(Removing an Optical Drive on page
(Removing the Hard Drive on page
Removing the power switch cable
Removing the power switch
(Preparation for Disassembly on page
23).
24).
32).
22).
31).
35
Advertisement
Table of Contents
