Advertisement
4.9
Positioning the tension pole
See Fig.4-9-1.
Tension arm sub
assembly
[ D ] section
4.9.1 Adjustment Method
Note:
• Remove the cassette housing assembly in advance.
(1) Set the mechanism mode to the PLAY mode. (See 4.2.2
Mechanism modes)
(2) Loosen a screw [A].
(3) Check the location of the tip (section [B]) of the tension
arm assembly to make sure that it is within area [C]. If it
is located outside, turn part D to bring it within the spec-
ified area.
(4) Tighten the screw [A].
Note :
Tightening torque for the screw [A] : 0.06 N.m (0.6kgf.cm)
[ B ] section
[ C ]
screw [A]
Fig.4-9-1
(No.YD085)1-29
Advertisement
