Diskette drive (optional)
This section describes how to remove and install a diskette drive.
Removing a diskette drive
1.
Disconnect power from the system
access panel
(Removing the front bezel on page
2.
Disconnect the power (1) and data (2) cables from the back of the diskette drive.
Figure 4-45
3.
Lift the green drive-lock release tab (1) and gently slide the drive out of the chassis at the same
time (2).
Figure 4-46
NOTE:
To install a diskette drive, reverse the previous steps. You might need to remove the front bezel
to install the drive.
ENWW
(Predisassembly procedures on page
(Removing the side access panel on page
68).
Disconnecting the diskette drive cables
Removing the diskette drive from chassis
58), remove the side
64), and then remove the front bezel
Removing and replacing components
95