Pioneer DJM-800 Service Manual page 134
Pioneer dj mixer/ rotary volume kit
Hide thumbs
Also See for DJM-800:
- Service manual (158 pages) ,
- Operating instructions manual (128 pages) ,
- Manual del instrucción (24 pages)
Table of Contents
Advertisement
1
DJM-800
Order of updating
A
1. Update of the DSP program (if required)
2. Update of DSP data (if required)
3. Update of the microcomputer software
Note: Be sure to update the microcomputer software after updating of the DSP program and
/or DSP data is performed.
How to update the microcomputer software
1. For the method for updating the microcomputer software, see "How to use the Flash Development Toolkit."
(The updating method is the same as with the EFX-1000.)
B
Use "djm800_xxxx.mot" as the update file.
Note: If the Flash Development Toolkit is not installed on your PC,
see "How to install the Flash Development Toolkit."
How to update the DSP program and DSP data
How to update the DSP program
1. Update the DSP program of the DJM-800, using the "dsp_upp_xxxx.mot" update file, in the same way
as with the microcomputer software.
2. After disconnecting the special tool from the DJM-800, turn the DJM-800 on.
C
3. Once data transmission to and writing on the DSP FLASH starts, wait until the message
"UPDATE END" is displayed on the FL display. The LED for the TAP button is unlit while the
DJM-800 is starting up, flashes while the DSP program is being updated, then lit after
the updating is finished.
4. Updating of the DSP program is completed when "UPDATE END" is displayed on the FL display
or the LED for the TAP button lights up.
5. If updating of DSP data is required, go to "How to update DSP data."
If it is not required, update the microcomputer software, using the "djm800_xxxx.mot" update file.
How to update DSP data
D
1. Update DSP data of the DJM-800, using the "dsp_upd_xxxx.mot" update file, in the same way as with
the microcomputer software.
2. After disconnecting the special tool from the DJM-800, turn the DJM-800 on.
3. Once data transmission to and writing on the DSP FLASH starts, wait until the message
"UPDATE END" is displayed on the FL display. The LED for the TAP button is unlit while the DJM-800
is starting up, flashes while DSP data are being updated, then lit after the updating is finished.
4. Updating of DSP data is completed when "UPDATE END" is displayed on the FL display or
the LED for the TAP button lights up.
5. Be sure to update the microcomputer software, using the "djm800_xxxx.mot" update file.
E
F
134
1
2
DJM-800
2
3
3
4
4
- Quick Links:
- Exploded Views and Parts List
- Diagnosis
Hide quick links:
Advertisement
Table of Contents
