FIRE TEST ? (continued)
Faulting a point more than once does not increment the test
count. However, the command center emits a brief tone and
displays the point text each time you fault the point,
allowing you to test multiple devices assigned to one point.
5.
When all points have been tested, 0 PTS TO TEST is
displayed. Press [ESC]. The display momentarily shows
ALL PTS TESTED before returning to idle text.
6.
During the Fire Test you may want to see the points that
remain untested. Press the [ESC] key and VIEW
UNTESTED ? is displayed. Press [ENT]. The display
shows # PTS UNTESTED. Press [NEXT] to see a list of
the points that were not yet tested. Move through this list
by pressing the [NEXT] key. To resume the Fire Test, press
[ESC]. ## PTS TO TEST is displayed.
Press [ESC] twice to leave the Fire Test mode.
Automatic time-out returns the system to idle text: If there is no
point or command center activity for 20 minutes, the fire test ends
automatically. The command center returns to idle text.
15