7.
Installation
Securing to the wall
sufficient, reinforcement must be done to prevent the transfer of vibration.
be damaged and may become highly dangerous.
Be sure to do
Item
not inflict injury.
piping while drilling holes.
3. Determine the positions for the remaining four screws
remove the unit.
insert and tighten the remaining four screws.
not enter the building from screws mounting the
device.
the right if this water heater is installed at an altitude
remote controller and a cease in operation. If this
occurs, disconnect, then reconnect power to the
water heater to reset the system.
10
CAUTION
Illustration
(upper)
Tapping Screw
* Do not change any other dipswitches.
* High elevation adjustment.
5
6
0 - 2,000 ft (0 - 610m)
2,001 - 4,000 ft (611 - 1,220m)
4,001 - 6,000 ft (1,221 - 1,830m)
6,001 - 8,000 ft (1,831 - 2,440m)
ON=
OFF=