Advertisement
Model 5304 A
Installation
S E C T I O N IX D
5 3 0 4 A T I M E R / C O U N T E R
S U B S E C T I O N II
I N S T A L L A T I O N
9D-2-1. UNPACKING A N D INSPECTION
9D-2-2. If the shipping carton is damaged ask that
the carrier's agent be present when the instrument
is unpacked.
Inspect the instruments for damage
such as scratches, dents, broken knobs, etc.
If the
instrument is damaged or fails to meet performance
tests when used with the 5300A Measuring System
notify the carrier and the nearest Hewlett-Packard
Sales and Service office immediately.
Performance
check
procedures are located in Section IX D-5,
and Sales and Service offices are listed in Section VI
of the 53(H)A portion of the manual.
Retain the
shipping carton and the padding material for the
earner's inspection.
The Sales and Service office
will arrange for the repair or replacement of the
instrument without waiting for the claim against
the carrier to be settled.
9 D - 2 - 3 . STORAGE A N D S H I P M E N T
9D-2-4. PACKAGING. To protect valuable electronic
equipment during storage or shipment always use
the best packaging methods available. Your Hewlett-
Packard
Sales
and
Service
office can
provide
packaging material such as that used for original
factory packaging. Contract packaging companies in
many
cities
can
provide
dependable
customer
packaging on short notice. Here is one recommended
packaging method:
a. The original container is a corrugated
card-
board box with 200 lbs. burst test (HP No. 9211-1620).
The instrument is secured and protected, while in
the box by a top and bottom molded form of
polystyrene foam (HP No. 9220-1545). Also included
with the instrument is a plastic dust-protection cover
HP Part No. 05300-80004.
9D-2-5. INSTALLATION ANI) REMOVAL
OF PLUG-ON
9I)-2-(>. The 5304A Timer/Counter must be used with
a mating 5300A
Measuring
System
before any
measurements can be made.
To mate the 5304A
Timer/Counter with the 53(H)A Measuring System, see
Figure 2-1 and Paragraph 2-1 of the 5300A portion
of the manual.
9D-2-7.
ENVIRONMENT.
Conditions
during
storage and shipment should be normally limited
as follows:
a.
Maximum altitude: 25,000 feet
b. Minimum temperature: -40°F ( 40°C).
c. Maximum temperature: +167"F(+75°C).
9 D - 2 - 8 . PORTABLE OPERATION
9D-2-9.
The use of the HP Model 531 OA Battery
Pack enables the 5300A Measuring System and 5304 A
Timer Counter to be used in areas removed from ac
power sources. The 531 OA Battery Pack provides a
minimum of 3 hours operation (typically 5 hours) at
20°C to 30°C operating and charging temperature.
Tables 1-2 and 1-4 of 5300A portion of the manual
list the HP 5310A Battery Pack as an available
accessory.
Documentation on the 531 OA is also
included in Section IV through VIII ol the 5300A
portion of the manual. To prepare the 5300A 5304A
for portable operation, refer to Paragraph 2-15 and
Figure 2-2, steps a to c of 5300A portion of manual.
9D-2-1
Advertisement
