JVC VN-H37U Instructions Manual page 67
Hd network camera
Hide thumbs
Also See for VN-H37U:
- Instructions manual (114 pages) ,
- Operation manual (20 pages) ,
- Instructions (4 pages)
Table of Contents
Advertisement
Encoder No.1 to No.3 Sets the manual streaming of Encoder No.1 to Encoder No.3.
A
Encoding
B
FrameSize
C
FrameRate
D
Destination
Address
E
Destination
Port
F
Start
Audio (VN-H57U/H257U/H257VPU/H157WPU only)
G
Destination
Address
H
Destination
Port
I
Start
Memo:
● If the camera power supply is turned Off during multicast streaming, the camera will restart multicast
streaming automatically after the camera is restarted.
● Settings A~I are not displayed when the encoder is set to "OFF".
Displays the A EncodeB being set for each encoder.(A Page 27)
[Display values: JPEG, H.264 Baseline, H.264 High, MPEG4)]
Displays the "FrameSize" being set for each encoder. (A Page 26)
Displays the AFrameRateB being set for each encoder. (A Page 26)
You can change it if the encoding is AJPEGB.
[Set values: 30 fps to 5 fps to 1/30 fps]
Memo:
● You can change the frame rate if it is below the limit specified on the
[Basic Setting2] page or on the [Encode] page.
Sets a destination address for encoded data streaming.
Set a multicast address. If you have another device for multicast streaming,
set a different multicast address.
[Factory default: Encoder No.1: 225.0.1.1, Encoder No.2: 225.0.2.1,
Encoder No.3: 225.0.4.1]
Sets a destination port number for encoded data streaming. Enter an even
number to meet the RTP. If you have another device for multicast streaming,
you should set a different port number.
If a port number is duplicated, you cannot receive multiple number of
multicast data using a single computer.
[Factory default: Encoder No.1: 49152, Encoder No.2: 59152,
Encoder No.3: 29152]
Saves the encoder settings, and starts manual streaming. The [Stop] button
is displayed during manual streaming.
You cannot change the frame rate, destination address, and destination port
during data distribution.
Memo:
● To save the settings made to the entire page, press the [OK] button.
Specifies the destination address for audio streaming.
Specify a multicast address. When used with other multicast transmitting
devices, set a separate multicast address for each device.
[Factory default: 225.0.3.1]
Specifies the destination port number for audio streaming.
Specify an even number in accordance with RTP.
When used with other multicast transmitting devices, it is recommended that
you set a separate port number for each device.
If the same port numbers are used, multiple multicasts will not be receivable
on a single computer.
[Factory default: 39152]
For starting and stopping manual distribution.
* The [Set values] in bold letters are factory defaults.
67
Hide quick links:
Advertisement
Table of Contents
