Advertisement
Installation Instructions
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS []
Are these
the right instructions
for your model?
Follow
the Installation
Instructions
indicated
by
the label on the back of the refrigerator--
[]
[]
[] []
[]
[]
[] []
[]
[]
[] [] or []
BEFORE YOU BEGIN
Read each step thoroughly
before
proceeding.
° CAUTION-
Unplug the
_
Refrigerator.
To eliminate
the danger
of electric
shock during
installation,
you must unplug
the refrigerator
from its electrical
outlet.
TOOLS YOU WILL NEED
FlatbladeandPhillips
Pliers
screwdrivers
Sharpknife
1/4" and5/16" Nutdrivers. o r adjustable wrench
[] REMOVE THE COVER
Use a nutdriver
or an adjustable
va-ench
to remove
the compressor
compartment
access cover. This
requires
removing
six screws which attach
the cover
to the back of the refrigerator
case.
Be sure to save the screws as the access cover must
be reinstalled
later to ensure
your refrigerator
will
function
properly.
[] ATTACH THE WATER VALVE
• Locate
the 3-pin male connector
plug (C). Plug
the water valve wire adapter (27) onto the male
connector
plug,
then plug it onto the male
terminals
on the water valve (4). Either
wire
can go on either
water valve terminal.
• Fasten the water valve to the cabinet
using
the
hex-head
screw (13) from
the kit.
[] INSTALL
WATER LINE CLAMP
• Attach the water line clamp (strain relief) (8) to
the refrigerator. Drive the screw (7) from the kit
through the clamp (8) and into the small hole
at the hack of the cabinet.
• The water line clamp is for the house water line
(see the Water Line Installation Instructions). It is
not to he used for the tubing from the water valve
up to the icemaker.
o
/®
32
Advertisement
