Related Manuals for Kenmore 790.75722991
Summary of Contents for Kenmore 790.75722991
- Page 1 RqD.q_q _q_ 2 --]ql).qG'] _pq_g- "1c]_), - -] 5 _ q_qq g- --lqB. -]_q g-'s_q \ -RqO.--15q L_ _q _qO. _16q _\ qq / _qqC.-]5_q/_a -lq_. q 54 g-$qo/\...
- Page 2 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion result causing property damage,...
- Page 3 Important Notes Installer Stepping, leaning or sitting on the doors Read all instructions contained in these installation or drawers of this range can result in serious injuries instructions before installing range. and can also cause damage to the range. Remove packing material from...
-
Page 4: Before Starting
Locate the Bracket Using the Template- (Bracket may Before Starting be located on either the left or right side of the range. Tools You Will Need Use the information below to locate the bracket For leveling legs and Anti-Tip Bracket: template is not available). - Page 5 Level and Position Range - Level range by adjusting the (4) leveling legs with a wrench. Note: A minimum clearance of 1/8" is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a spirit level to check your adjustments.
- Page 6 Manual Flare Flexible Flare U nion Pressure Read electrical connection details below Shutoff Union Appliance Adaptor Regulator and connect electricity to range. Valve_ Conduit Before servicing, disconnect electrical supply at circuit breaker, fuse or power cord. Electric Reouirements: An individual, properly grounded Sen/ice Shut-Off Valve Electric Ignition models only _ and polarized branch circuit protected by a 15 amp.
- Page 7 Operation of Surface Burners Ignition Electric Surface Burners Operation of electric igniters should be checked after range This range is equipped with sealed burners as shown and supply line connectors have been carefully checked for below. leaks and range has been connected to electric power. The surface burner gas valves have detent positions in both the Off and LITE positions.
- Page 8 The approximate flame length of the oven burner is 1 inch Operation of Oven Burners and (distinct inner, blue flame). Oven Adjustments To determine if the oven burner flame is proper, remove the 9. Electric Ignition Burners oven bottom and burner baffle and set the oven to bake at 0 peration of electric igniters should be checked after range 300°F.
-
Page 9: Before You Call For Service
Optional Spice Rack 12.Make Sure Range is Level. Level the range by placing a level horizontally on an oven Some models are equipped with an optional spice rack. Follow the instructions below for installation: rack. Check diagonany from front to back, then level the range by either adjusting the leveling legs or by placing Using a 1/4"...