Drill Model D 13VB3 Handling instructions Note: Before using this Electric Power Tool, carefully read through these HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as an important reference when using this power tool.
c) Avoid accidental starting. Ensure the switch is in GENERAL SAFETY RULES the off position before plugging in. Carrying power tools with your finger on the WARNING! switch or plugging in power tools that have the Read all instructions switch on invites accidents. Failure to follow all instructions listed below may result in d) Remove any adjusting key or wrench before electric shock, fire and/or serious injury.
PRECAUTION 2. Use auxiliary handles supplied with the tool. Keep children and infirm persons away. Loss of control can cause personal injury. When not in use, tools should be stored out of reach of 3. Before drilling into walls, ceilings or floors, ensure children and infirm persons.
NOTE Depth gauge When the sleeve does not become loose any further, fix the side handle to ring, hold side handle firmly, then turn the sleeve to loosen by hand (Fig. 3). Ring Side handle Loosen Tighten Loosen Sleeve Fig. 6 Side handle 8.
4. Inspecting the carbon brushes For your continued safety and electrical shock protection, carbon brush inspection and replacement Stopper on this tool should ONLY be performed by a Hitachi Authorized Service Center. 5. Replacing supply cord Speed control dial If the supply cord of Tool is damaged, the Tool must...
Page 8
Hitachi Koki Co., Ltd. Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo, Japan Code No. C99136412 E Printed in Ireland...