Table of Contents
Advertisement
Removing paper after take-up
After paper take-up, remove the take-up reel core as follows.
1. Turn off the Auto Take-up Reel Unit.
w
2. Press the Paper Source l button to select Roll Auto Cut On
.
Then press and hold the Enter
roll paper is cut automatically.
Note:
If you are printing on very thick roll paper, it is recommended that
you set the Auto Cut setting to off (on the printer's control panel
and in the printer driver) and press the
the printer to feed the paper, and then cut the paper yourself;
otherwise the paper cutter may be damaged. See "Cutting the roll
paper manually" on page 211.
3. Turn the lever to unlock the movable unit, and then slide it to
the left so that the flange knob clears the end of the take-up
reel core. While doing this, support the take-up reel core with
one hand to keep it from falling.
Warning:
Turn off the Auto Take-up Reel Unit before removing the
take-up reel core. If the take-up reel unit operates
unexpectedly, injury may occur.
button for 3 seconds. The
Paper Feed
Paper Handling
d button on
226
Advertisement
Table of Contents
Troubleshooting
