HP Integrity Superdome 2 16-socket Getting Started Manual page 9
Fabric extender
Hide thumbs
Also See for Integrity Superdome 2 16-socket:
- User manual (217 pages) ,
- Administrator's manual (110 pages) ,
- Service manual (104 pages)
Table of Contents
Advertisement
Associating a Fabric Extender to an EtherChannel
To associate the Fabric Extender to an EtherChannel, perform this task:
Command
Step 1
switch# configure terminal
Step 2
switch(config)# interface port-channnel
channel
Step 3
switch(config-if)# switchport mode
fex-fabric
Step 4
switch(config-if)# fex associate chassis
Step 5
switch# show interface port-channel
channel fex-intf
This example shows how to associate the Fabric Extender to an EtherChannel interface on the switch:
switch# configure terminal
Enter configuration commands, one per line.
switch(config)# interface port-channel 2
switch(config-if)# switchport mode fex-fabric
switch(config-if)# fex associate 100
switch(config-if)# exit
switch(config)# interface ethernet 1/19
switch(config-if)# switchport mode fex-fabric
switch(config-if)# fex associate 100
switch(config-if)# channel-group 2
switch(config-if)# exit
switch(config)# interface ethernet 1/20
switch(config-if)# switchport mode fex-fabric
switch(config-if)# fex associate 100
switch(config-if)# channel-group 2
switch(config-if)# exit
switch(config)# interface ethernet 1/21
switch(config-if)# switchport mode fex-fabric
switch(config-if)# fex associate 100
switch(config-if)# channel-group 2
switch(config-if)# exit
switch(config)# interface ethernet 1/22
switch(config-if)# switchport mode fex-fabric
switch(config-if)# fex associate 100
switch(config-if)# channel-group 2
switch(config-if)# exit
Note
You have to associate each Ethernet interface that is a members of the EtherChannel as a fabric interface
as shown in the above example.
This example shows how to display the association of the Fabric Extender and the switch:
switch# show interface port-channel 2 fex-intf
Fabric
Interface
---------------------------------------------------
Po2
FEX
Interfaces
Eth100/1/1
Eth100/1/2
Cisco Nexus B22 Fabric Extender for HP Getting Started Guide
Configuring the Cisco Nexus B22 Fabric Extender for HP
Purpose
Enters configuration mode.
Specifies an EtherChannel to configure.
Sets the EtherChannel to support an external Fabric
Extender.
Associates the chassis ID to the Fabric Extender unit
attached to the interface. The range of the chassis ID
is from 100 to 199.
(Optional) Displays the association of a Fabric
Extender to an EtherChannel interface.
End with CNTL/Z.
Eth100/1/3
Eth100/1/4
9
Advertisement
Table of Contents
