System Control System Adjustment; Initialization Of B, C, D, E, F Page Data; Battery End Check (Vc-217 Board) - Sony DCR-TRV8 Service Manual
Digital video camera recorder
Hide thumbs
Also See for DCR-TRV8:
- Operating instructions manual (164 pages) ,
- Service manual (22 pages) ,
- Operating instructions manual (163 pages)
Table of Contents
Advertisement
3-2.
SYSTEM CONTROL SYSTEM ADJUSTMENT
1. Initialization of B, C, D, E, F Page Data
If the B, C, D, E, F page data is erased due to some reason, perform
"1-2. INITIALIZATION OF B, C, D, E, F PAGE DATA", of "5-1.
CAMERA SECTION ADJUSTMENT"
2. Battery End Check (VC-217 board)
Check the battery end voltage.
Mode
Camera recording
Subject
Arbitrary
Switch setting
1) AUTO FOCUS ................................................................. OFF
2) LCD screen .................................................................. Closed
3) REC LAMP (Menu display) ............................................. ON
Connection:
1) Connect the regulated power supply and the digital voltmeter
to the battery terminal as shown in Fig. 5-3-4.
Adjusting method:
1) Adjust the output voltage of the regulated power supply so that
the digital voltmeter display is 6.0 ± 0.1Vdc.
2) Turn off the power supply.
3) Turn on the HOLD switch of the adjustment remote
commander.
4) Turn on the power supply.
5) Load a cassette, and set to the camera recording mode.
6) Check that the REC LAMP is lit continuously.
7) Decrease the output voltage of the regulated power supply so
that the digital voltmeter display is 5.50 ± 0.01Vdc.
8) Check that the REC LAMP blinks at 0.8 Hz.
Regulated power supply
5.5 } 0.01 Vdc
Digital volt meter
Fig. 5-3-4.
5-40
Hide quick links:
Advertisement
Table of Contents
