Note: If the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G registers to Cisco Unified Communications
Manager, web access to the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G gets set to read-only mode by
default. In this mode, firmware upgrades via the web interface are not allowed. Full web access must be enabled in Cisco
Unified Communications Manager in order to make changes.
Ultimately the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G will use what is set as the phone load in the
Cisco Unified Communications Manager.
Hardware Compatibility
The following hardware and software compatibility matrix displays the minimum firmware version for each hardware revision
of the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G.
To view the hardware revision information, select Information > Device from the Cisco Unified Wireless IP Phone 7925G,
7925G-EX, or 7926G webpage.
Model Type
7925G & 7925G-EX
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Deployment Guide
Hardware
Revision
Firmware Version
1.0
1.3(1)
1.1
1.3(2)
Minimum
127