Table of Contents
Advertisement
16
en | Installation
Figure?3.4?Flush mounting - electrical box (4S)
1.
2.
3.
3.3.3
Surface mounting
When using the surface mounting box:
–
–
–
–
–
–
–
AM18-Q0648 | v1.0 | 2013.03
Two screws (not supplied)
Integrated camera unit and base
4S electrical box
With a side connection, remove the cap covering the side
entrance.
With a rear connection, leave the cap in place.
Attach the conduit to the mounting box.
Release the two clips at the bottom of the watertight
connection compartment to remove it from the mounting
box.
Open the cover of the watertight compartment in the
mounting box by releasing the five clips.
Run the power and video cables through separate rubber
grommets into the watertight compartment.
Run the cable from the camera into the watertight
compartment through the supplied grommet.
Make the connection inside the watertight compartment
and clip on the cover to seal it.
Installation Manual
FLEXIDOME 5000 AN
Bosch Security Systems
Hide quick links:
Advertisement
Table of Contents
