Table of Contents
Advertisement
Configuring a DWX System
Making and Checking Network Settings
Follow the steps described below to make network settings and check the Cross Remote functions.
Step 1
Network setup
Step 2
Checking equipment
connections
Step 3
Checking for 2.4 GHz
interference
Step 4
Checking the monitor
function
Step 5
Checking the control
function
64
Making and Checking Network Settings
Specify the IP addresses and subnet masks of the devices connected to the network.
Verify that there are no IP address conflicts and that all devices connected to the network are
correctly installed and set up.
Use spectrum analyzer or WiFi analyzer application software to verify that there is no
interference in the frequency bands used for Cross Remote.
In a Cross Remote configuration, UHF reception forms parts of the network system. Use
Wireless Studio to check transmitter information received via WiDIF-HP and passed onto the
network.
While checking whether the obtained service area fulfills the requirements, determine the
installation location and number of RMU-01 units.
Advertisement
Table of Contents
