Table of Contents
Advertisement
ABOUT SURFACE COOKING
/k
CAUTI 3N
BEFORE COOKING
,, Do not use the glass cooktoD surface as a cutung board.
Do not olace or stere items that can melt or catch fire on the g=assCOOKtOD. e ven
when _t s not be ng used.
Turn the surface units on only after placing the ceoKware on them
Do net store heaw items above the ceokteo surface. They could fall and damage it.
Z_
DURING COOKING
CAUTION
= Do not place aluminum foil or elastic items such as salt ana Deeper snaKers, spoon
no_aers, or plastic wrappings on the range wnen _t_s_nuse. The hot air from the vent
could melt elastics or ignite flammable items.
Make sure the correct surface unit is turned on.
D Never cook food direct y on the glass. Always use ceeKware.
Always place tne Dan _nthe center of the surface unit you are COOKingon.
Never leave surface units unattenaea wme rising a n gh heat setting. Beilevers cause
smoKing and greasy spulovers that _naj catch on fire.
Turn the surface units off before removing coeKware.
Do net use plastic wrap to cover food. Plastic may melt onto the surface and be very
difficult to remove.
z_
AFTER COOKING
CAUTIOi'.
= Do not toucn the surface units until they have coolea aown.
The surface may be still be hot and burns may occur if the glass surface is touched
before it has cooled down sufficient y.
Immediately clean sDuls on the cooking area to prevent a tough cleaning cnere later.
If yOb nave a cabinet d_rectly above the cooking surface, maKe sure that the _tems
q _tare nfrequently usea and can be safely stored _nan area subjected to heat.
Temoeratures n the cabinet ma, be unsafe for items sucn as volatile lloulas, cleaners.
and aerosol sprays.
About the radiant surface elements
The temperature of radiant surface elements rises gradually and evenly. As the temperature rises,
the radiant element will glow red. To maintain the selected setting, the element will cycle on and
off. The heating element retains enough heat to provide a uniform and consistent heat during the
off cycle. For efficient cooking, turn off the element several minutes before cooking is complete.
This will allow residual heat to complete the cooking process.
®
Radiant elements have a limiter that allows the element to cycle ON and OFF, even at the HI
setting. This helps to prevent damage to the ceramic cooktop. Cycling at the HI setting is
normal and can occur if the cookware is too small for the radiant element or if the cookware
bottom is net flat.
17 Surface cookng
- Quick Links:
- Features
- Self-Cleaning Ovens
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
