Storing Outboard Motor; Procedure - Yamaha F15C Owner's Manual
Hide thumbs
Also See for F15C:
- Owner's manual (126 pages) ,
- Owner's manual (90 pages) ,
- Owner's manual (104 pages)
Table of Contents
Advertisement
Maintenance
outboard motor to protect it from damage.
EMU28241
Storing outboard motor
When storing your Yamaha outboard motor
for prolonged periods of time (2 months or
longer), several important procedures must
be performed to prevent excessive damage.
It is advisable to have your outboard motor
serviced by an authorized Yamaha dealer
prior to storage. However, you, the owner,
with a minimum of tools, can perform the fol-
lowing procedures.
ECM01080
CAUTION:
To prevent problems which can be
G
caused by oil entering the cylinder from
the sump, keep the outboard motor in
the attitude shown when transporting
and storing it. If storing or transporting
the outboard motor on its side (not up-
right), put it on a cushion after draining
the engine oil.
Do not place the outboard motor on its
G
side before the cooling water has
drained from it completely, otherwise
water may enter the cylinder through
the exhaust port and cause engine trou-
ble.
Store the outboard motor in a dry, well-
G
ventilated place, not in direct sunlight.
EMU28303
Procedure
EMU32040
Flushing in a test tank
1.
Dismount the outboard motor from the
boat. For further details, see page 50.
2.
Wash the outboard motor body using
fresh water. For further information, see
page 55.
3.
Fill the fuel tank with fresh fuel and add
one ounce of "Yamaha Fuel Conditioner
52
and Stabilizer" (Part No. LUB-FUELC-
12-00) to each gallon of fuel.
NOTE:
The use of "Yamaha Fuel Conditioner and
Stabilizer" eliminates the need to drain the
fuel system. Consult your Yamaha dealer or
other qualified mechanic if the fuel system is
to be drained instead.
4.
Disconnect the fuel line from the out-
board motor.
5.
Remove the engine top cowling and si-
lencer cover. Remove the propeller. For
further details, see page 67.
6.
Position the outboard motor on a water
tank. For further details, see page 25.
1. Water surface
2. Lowest water level
7.
Fill the tank with fresh water to above the
level of the anti-cavitation plate.
ECM00300
CAUTION:
Do not run the engine without supplying
it with cooling water. Either the engine
water pump will be damaged or the en-
gine will be damaged from overheating.
Before starting the engine, be sure to
supply water to the cooling water passag-
1
2
ZMU02051
- Quick Links:
- Engine Oil
Hide quick links:
Advertisement
Table of Contents
