Table of Contents
Advertisement
Installation
Instructions
U N PACKI NG SPACE MAKER'"
ITI
Remove tape
two corner pads
rear
and
from
bottom corners of appliance.
ITI
using
shipping corner posts, lay
the four
the
appliance on its left side so the shipping base does
not rest on the floor.
Plastic spacer
blocK_
Mechanism
shipping
bolt
Shipping
blocks
Shipping
Rear vent
cli )s
onl9
• Drainhose
Foam
shipping pad
Shipping carton
corner posts
r_
Remove
shipping pad.
the foam
F4-1 Remove the washer
bolt
the ratchet
shipping
using
with 3/8" socket and remove the plastic spacer
block using the slipjoint pliers.
rs-i
Return
appliance to
upright position
the
the
and
locate it in the general area to be installed. Provide
enough space at the rear for installing the water
inlet hose.
Untape and open washer lid.
Remove:
a. foam tub blocking pad
b. foam shipping blocks from rear of unit
c. tape from druer door
d. foam dryer support pads
e. inlet hoses
f. From the back of the washer, remove the wire
shipping clips securing the drain hose, Plastic
clamps secure the drain hose to the right side
of the washer backsheet. These clamps form a
standpipe to prevent water siphoning. DO NOT
REMOVETHESECLAMPS.
Dryer
support pads
UNPACKING
SPACEMAKER'"
(CONT.)
NOTE:
T he tub blocking pad, shipping bolt and plastic
spacer should be retained for use if the appliance is
transported at a later date.
F81 Remove clips holding
following:
the
a. inlet hoses
b. drain hose
c. power cord
PREPARING DRAIN HOSE
E_
Form
the end of the drain hose with
a
IfU_
shape
on
the hose pointed toward the drain.
r_lFor
an
requiring a longer
hose,
installation
drain
use the WH41X312 extra-long (108") drain hose.
Attach to the machine in the same manner as the
original hose.
Advertisement
Table of Contents
