Table of Contents
Advertisement
To set up Speaker Balance
You can set the sound level of the desired channel.
(t%
To set up Speaker Balance
1
Press the SOUND EDIT button. Each time the Use the LEFT/RIGHT ( 4/
) button to raise
button is pressed, the selection switches as or lower the output level of the chosen
shown below. speaker(s).
Example : 5.1CH Sound Setup
-00 F-00
Front Speakers: L level, R level
00 la-00
Rear Speakers: L level, R level
0048
Center Speaker
Rear S1eakers
Subwoofer Speaker
OFF, range of -06 - 00
OFF, range of -06 -- 00
range of - 06 - -00 - +06
range of - 06--00-+06
range of-06--00-+06
1 • The display changes depending on the current audio output mode ( PRO LOGIC II,
STEREO, etc.).
•
1
Press the TEST TONE button on the remote control.
• This function allows you can easily adjust the sound balance
of the speakers from the listener's position.
• The test signal will be sent to the Left Front - Center -.
Right Front Right Rear Left Rear -» LFE in that order.
Lflfl
l • While in STEREO or PRO LOGIC mode , TEST TONE may operate
differently for VCDs or CDs.
• When playing a DVD or CD, this will work only in STOP mode.
Advertisement
Table of Contents
