Advertisement
Available languages
Available languages
12_ Mobile
or manufactured
home instalkstion
• Installation
MUST conform
to the MANUFACTURED
HOME
CONSTRUCTION
& SAFETY STANDARD,
TITLE 24, PART
32-80
or, when such standard
is not applicable,
with
AMERICAN
NATIONAL
STANDARD
FOR MOBILE HOME,
ANSI/NFPA
NO. 501B.
• The appliance
MUST be vented to the outdoors
with the
termination
securely fastened
to the mobile
home structure.
• The vent MUST NOT be terminated
beneath
a mobile
or
manufactured
home.
• The vent duct material
MUST BE METAL.
• KIT 14-D346-33
MUST be used to attach
the appliance
se-
curely to the structure.
• The vent MUST NOT be connected
to any other duct, vent,
or chimney.
• Do not use sheet metal screws or other fastening
devices
which extend
into the interior
of the exhaust vent.
• Provide an opening
with a free area of at least 25 sq. in for
introduction
of outside air into the dryer
room.
13_ Alcove
or closet
installation
• If your appliance is approved for installation in an alcove or
closet, it will be stated on a label on the appliance
back.
• The dryer MUST be vented to the outdoors. See the EXHAUST IN-
FORMATION section.
• Do not install this appliance with less than the minimum clear-
ances shown above.
• The closet should be vented to the outdoors to prevent gas pock-
eting in case of a gas leak in the supply line.
• No other fuel-burning appliance shall be installed in the same
closet with the appliance.
CONSIDERATION MUST BE GIVEN TO PROVIDE ADEQUATE
CLEARANCES FOR INSTALLATION AND SERVICE.
DOOR
VENTILATION
OPENING
A minimum
of 120 square inches of opening,
equally
divided
at top and bottom,
is required.
Air openings
are required
to
be unobstructed
when a door is installed.
A Iouvered
door
with equivalent
air openings
for the full length of the door is
acceptable.
.......1
i
60 Sq.In.
Sqn
When
louvers or registers are placed
in door openings, the
free air openings
of the louvers or registers must equal 120
square inches.
14_ IIBathroom or bedroom
installation
• The appliance
MUST be vented to the outdoors.
See EX-
HAUST INFORMATION
section 6 & 7.
• The installation
must conform
with local codes or, in the ab-
sence of local codes, with the NATIONAL
ELECTRICAL
CODE, ANSI/NFPA
NO. 70 and NATIONAL
FUEL GAS
CODE, ANSI Z223.
15_ Servicing
LABEL ALL WIRES PRIOR TO DISCONNEC-
TION
WHEN
SERVICING
CONTROLS.
WIR-
ING ERRORS CAN CAUSE IMPROPER AND
DANGEROUS
OPERATION
AFTER SERVIC-
ING/INSTALLATION.
For replacement
parts and other information,
see the back
cover of this Use & Care Guide
for service phone numbers.
DO NOT
INSTALL THIS APPLIANCE
IN A
CLOSET WITH A SOLID DOOR.
29
Advertisement
