Link Debounce Timer; Important Points To Remember About Link Debounce Timer - Dell Force10 C150 Configuration Manual
Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs
Also See for Force10 C150:
- Manual (57 pages) ,
- Manual (66 pages) ,
- Quick start manual (33 pages)
Table of Contents
Advertisement
To test the condition of cables on 10/100/1000 BASE-T modules, use the
Step
Command Syntax
tdr-cable-test gigabitethernet
1
<port>
show tdr gigabitethernet
2
<port>
Link Debounce Timer
Link Debounce Timer
This feature is supported on E-Series ExaScale
The Link Debounce Timer feature isolates upper layer protocols on Ethernet switches and routers from
very short-term, possibly repetitive interface flaps often caused by network jitter on the DWDM equipment
connecting the switch and other devices on a SONET ring. The Link Debounce Timer delays link change
notifications, thus decreasing traffic loss due to network configuration. All interfaces have a built-in timer
to manage traffic. This feature extends the time allowed by the upper layers.
The SONET ring has its own restore time whenever there is a failure. During this time, however,
the Ethernet interface connected to the switch will flap. Link Debounce Timer instructs the
Ethernet switch to delay the notification of the link change to the upper layers. If the link state
changes again within this period, no notification goes to the upper layers, so that the switch
remains unaware of the change.
Note: Enabling the link debounce timer causes link up and link down detections to be delayed, resulting in
traffic being blackholed during the debouncing period. This situation might affect the convergence and
reconvergence of some Layer 2 and Layer 3 protocols.
Important Points to Remember about Link Debounce Timer
•
Link Debounce Timer is configurable on physical ports only.
•
Only 1G fiber, 10/100/1000 copper, 10G fiber, 10G copper are supported.
•
This feature is not supported on management interfaces or SONET interfaces.
•
Link Debounce takes effect only when the operational state of the port is up.
•
Link Debounce is supported on interfaces that also have link dampening configured.
•
Unlike link dampening, link debounce timer does not notify other protocols.
446
|
Interfaces
Command Mode
EXEC Privilege
<slot>/
EXEC Privilege
<slot>/
is supported on platform
Usage
To test for cable faults on the GigabitEthernet
cable.
•
Between two ports, the user must not start
the test on both ends of the cable.
•
The user must enable the interface before
starting the test.
•
The port should be enabled to run the test
or the test prints an error message.
Displays TDR test results.
e
e
x with FTOS 8.2.0.1 and later
tdr-cable-test
command:
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
