Rear Panel View; Icro Component System; Where To Install Your Micro Component System; Connecting Your System To The Power Supply - Samsung MM-UC8 Instruction Manual

Micro component audio system with usb host mp3-cd/cd-r/rw playback
Table of Contents

Advertisement

Rear Panel View

B
1. AM Aerial Connector Terminals
2. SW Aerial Connector Terminal(option)
3. FM Aerial Connector Terminal
4. AUX-Input
5. Loudspeaker Connector Terminals
6. Voltage Selector(option)
6
Where to Install Your
Micro Component System
To take full advantage of your new micro component system,
follow these installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
Maintain an open space of approximately 6 inches (15 cm) on the sides
and rear of the system, for ventilation purposes.
Make sure that you have enough room to open the compact disc com-
partment easily.
1
Place the loudspeakers at a reasonable distance on either side of the
system to ensure good stereo sound.
2
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers are placed at
an equal distance above the floor.
3
4
5
6
Connecting your System to the
Power Supply
The main lead must be plugged into an appropriate socket.
Before plugging your system into a main socket, you must check
the voltage setting (OPTIONAL). If the voltage of the socket does
not correspond to the setting on the rear of the unit, you may
seriously damage your system.
1
Check the position of the Voltage selector on the rear of the system
(OPTIONAL).
2
Plug the main lead into an appropriate socket.
3
Press the

Inserting Remote Control Batteries

Insert or replace remote control batteries when you:
Purchase the micro component system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and never
mix alkaline and manganese batteries.
1
Place your thumb on the position marked
compartment cover (rear of the remote control) and push the cover in
the direction of the arrow.
2
Insert two AAA, LR03 or equivalent batteries, taking care to respect
the polarities:
3
Replace the cover by sliding it back until it clicks into position.
button to switch your micro-component system on.
on the battery
+ on the battery against + in the battery compartment
– on the battery against – in the battery compartment
7
GB

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents