Table of Contents
Advertisement
3.1.2 Setting of communication parameters
To enable F10M communication, set following parameters to the inverter. The parameters will be validated by
rebooting a power supply or changing a reset setting (f899) to1.
When interrupting a transmission to change the setting of command input, reboot a power supply if necessary,
since the data which have been received before the interruption of transmission are stored in the inverter.
Operation command mode selection
cmod
(Set this parameter to 4 to carry out run/stop with F10M communication.)
Speed setting mode selection
fmod
(Set this parameter to 9 to execute frequency command with F10M communication.)
Inverter number
f802
Data type selection
f830
Input reference setting 1
f831
Input reference setting 2
f832
Input reference setting 3
f833
Input reference setting 4
f834
Input reference setting 5
f835
Input reference setting 6
f836
Monitor output setting 1
f841
Monitor output setting 2
f842
Monitor output setting 3
f843
Monitor output setting 4
f844
Monitor output setting 5
f845
Monitor output setting 6
f846
f850
Communication error selection
f851
Communication error detecting time
f899
Reset function (1 to reset)
11
E6580772
Advertisement
Table of Contents
