Download Print this page

Whirlpool 3397512 Installation Instructions Manual

Thin twin washer-dryer four-wire 240 volt

Advertisement

Quick Links

IMPORTANT:
Read and save
these instructions.
IMPORTANT
Installer:
Leave Installation
Instructions
with the homeowner.
Homeowner:
Keep Installation
Instructions
for future reference.
Save Installation
Instructions
for local
electrical
inspector's
use.
Part No. 3397512
\Nasher
l
Dryer
Four-wire al0 vat

Advertisement

loading

Summary of Contents for Whirlpool 3397512

  • Page 1 Part No. 3397512 IMPORTANT: Read and save these instructions. \Nasher Dryer IMPORTANT Installer: Leave Installation Instructions Four-wire al0 vat with the homeowner. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use.
  • Page 2: For Your Safety

    30-amp-rated, four-wire, flexible type, power supply 1 FOR YOUR SAFETY: U.L.-llsted strain cord (pigtail) and a relief or Whirlpool Part No. 687000 to fit 3h:’ u.L.-listed strain relief one-inch Do not exhaust dryer into a hole. [See Figure I). Where local codes...
  • Page 3 (If the use Exhaust Deflector Kit LCK4500 legs don’t adjust, go through step 3 available from your Whirlpool dealer. Exhausting the dryer through the side of the washer/dryer requires use of Side Exhaust Kit LCK4600. Follow...
  • Page 4 Remove the 2 rear corner posts and cardboard pieces attached to the Remove the back of the washer/dryer. Remove yellow card. Take hoses out the two corner pieces attached of basket. Place hoses with other lower front of the washer/dryer. parts.
  • Page 5 IMPORTANT: THIS PROCEDURE MUST BE FOLLOWED TO ASSURE PROPER Use new hoses and washers INSTALLATION. that came with your Whirlpool washer/dryer. Drain Clamp Hose Move washer/dryer close to final position. Put “hook“ end of drain hose into laundry tub or standpipe.
  • Page 6 To get the most efficient use from dryerand place with your new washer/dryer, read your othershipping pieces. If the Whirlpool Use and Care Guide. exhaust ductwork cannot 1 Congratulations! ) be connected from the side of the washer/dryer,...
  • Page 7: Alternate Exhaust Methods

    Alternate exhaust To convert to a three- connect a separate grounding wire - wire electrical supply methods system. Use grounding wire and clamp The washer/dryer installed in a must assembly (Part No. 685463) or No. 10 mobile home be exhausted When local codes...
  • Page 8 When local codes... When local codes... When local codes.. . DC NOT Permit DC NOT permit the use of a flexible the use of the flexible Permit the use of a flexible-type 3-wire power supply cord and power supply cord and power supply cord (pigtail) but Permit copper power supply cable...
  • Page 9: Product Dimensions

    24 sq. in, Side View Front view Closet installation exhausted. Part No. 3397512 01992 Whirlpool Corporation Prepared by Whirlpool Corporation, Benton Harbor, Michigan 49022 Printed in U.S.A.