Ink Low; No Ink Cartridge; Not Registered; Out Of Memory - Brother MFC-J430W Basic User's Manual
Hide thumbs
Also See for MFC-J430W:
- Basic user's manual (121 pages) ,
- User manual (41 pages) ,
- Quick start manual (22 pages)
Table of Contents
Advertisement
Error Message
Ink low
Low Temperature
No Caller ID
No Ink Cartridge
No Paper Fed
No Response/Busy
Not Registered
Out of Memory
62
Cause
One or more of the ink cartridges are
near the end of their life. If a sending
machine has a colour fax to send, your
machine's "handshake" will ask that
the fax be sent as monochrome. If the
sending machine has the ability to
convert it, the colour fax will be printed
at your machine as a monochrome
fax.
The print head is too cold.
There is no incoming call history. You
did not receive calls or you have not
subscribed to the Caller ID service
from your telephone company.
An ink cartridge is not installed
correctly.
The machine is out of paper or paper
is not correctly loaded in the paper
tray.
The paper is jammed in the machine.
Paper dust has accumulated on the
surface of the paper pick-up rollers.
The Jam Clear Cover is not closed
correctly.
The number you dialled has not
answered or is busy.
You tried to access a Speed Dial
number that is not programmed.
The machine's memory is full.
Action
Order a new ink cartridge. You can
continue printing until the LCD shows
Cannot Print. (See Replacing the
ink cartridges uu page 53.)
Allow the machine to warm up.
If you want to use the Caller ID feature
call your telephone company. (See
Caller ID uu page 34, 36 and 38 for
your relevant country.)
Take out the new ink cartridge and re-
install it slowly until it clicks. (See
Replacing the ink cartridges
uu page 53.)
Do one of the following:
Refill the paper in the paper tray,
and then press Mono Start or
Colour Start.
Remove the paper and load it
again, and then press Mono Start
or Colour Start. (See Loading
paper and other print media
uu page 11.)
Remove the jammed paper by
following the steps in Printer jam or
paper jam uu page 66.
Clean the paper pick-up rollers.
(uuAdvanced User's Guide: Cleaning
the paper pick-up rollers)
Check the Jam Clear Cover is closed
evenly at both ends. (See Printer jam
or paper jam uu page 66.)
Verify the number and try again.
Set up the Speed Dial number. (See
Storing Speed Dial numbers
uu page 46.)
If a copy operation is in process
Press Stop/Exit and wait until the
other operations that are in progress
finish, and then try again.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
