Panasonic KX-T336 System Reference Manual page 652
Hide thumbs
Also See for KX-T336:
- System reference manual (1605 pages) ,
- Installation instructions manual (872 pages) ,
- Manual (95 pages)
Table of Contents
Advertisement
2.02 Loading Procedure
First, confirm that the preparations
for the start of
6. Release the Data Send mode of the backup
communication
have been made.
device.
l
The communication
parameters
must be the
same for sender and receiver.
7. When the remote operation is terminated,
the
system is reset automatically.
l
The system will do an "auto baud" to adjust its
baud rate to the remote terminal (300 or 1200
baud).
Using the protocol CRC-lG/CRT-CCITT
1.
Without the protocol
Enter the loading command.
Refer to the explanations
for without protocol
in regard to (a) Command format and (b) Item
explanation.
-:
7
1. Enter the loading command.
(a) Command format
OPE>LOD + Item 1 + Item 2
2. The loading start message
"Transfer start"
(b) Item explanation
Item
1 : 1
to
4
1. ALL Data
2.
PBX Date
3.
ATT1 Local Date
4. ATT2 Local Data
appears on the screen, and the system waits
for Protocol Linking.
3. Change the remote terminal to protocol data
send mode.
Refer to Section 16-B-3.03 "Loading
Procedure" about description of Item 1.
When the protocol link has been established,
the selected data is transferred
in binary
format from the remote terminal to the
system.
4.
Item 2 : 1 to 3
1. No procedure (Hex)
During the loading, the system automatically
shifts to off-line mode while holding the
speech path.
. .
2. CRC-16 (binary code decimal) available
only in remote.operation
3. CRC-CCfTT (binary code decimal)
available only in remote operation
2. The loading start message "Transfer start"
appears on the screen, and the system waits
for the data from the remote terminal.
5. When loading the selected data is finished,
the protocol link is disconnected
automatically,
and the protocol data send
mode changes to non-protocol
communication
mode and the following
message appears on the screen.
"Transfer end"
3. Change the terminal to data send mode.
Selected data is transferred
as ASCII codes
from the remote terminal to the system.
6. Remove the terminal from protocol data send
mode.
7.
4. When loading the selected data from a
remote terminal begins, the system
automatically
shifts to off-line mode while
holding the speech path.
5. When loading the selected data is finished,
the following message appears on the screen.
\
'7ransfer end"
You can edit the loaded data from a remote
location. And if you want to reset the system
(enters to on-line mode), replace the handset
and stop the data communication.
After
loading the selected data, if the system
detects "no carrier," the system is reset
automatically.
17-B-4
Advertisement
Chapters
Table of Contents
