Table of Contents
Advertisement
Chapter 4 Command Reference
Introduction
:DISPlay Subsystem
This subsystem controls the selection and presentation of textual information on
the Counter' s display. This information includes measurement results. :DISPlay is
independent of, and does not modify, how data is returned to the controller.
See the section titled "How to Program the Counter to Display Results" in Chapter
3 of this guide.
:DISPlay:ENABle <Boolean>
Sets or queries whether the whole display (text area, annunciators, and
indicators— with the exception of Remote and SRQ) is visible.
Query Response
Comments
:DISPlay:MENU[:STATe] OFF
This command, which only allows the OFF parameter, disables the menu display.
When the menu display is disabled, the results display appears.
The query indicates whether the menu display or result display is enabled.
Query Response
Comments
Programming Guide
Single ASCII-encoded byte, 0 or 1.
A value of 0 indicates OFF; a value of 1 indicates ON.
*RST: ON
This value is unaffected by save/recall.
Single ASCII-encoded byte, 0 or 1.
A value of 0 indicates the menu display is disabled (the result display is
enabled). A value of 1 indicates the menu display is enabled (the result display
is disabled).
*RST: OFF
To enable the menu display, use either the front-panel keys or the :SYST:KEY
command.
This value is unaffected by save/recall.
4-37
Advertisement
Table of Contents
