2 IP Adr.
This is the device's IP address.
Edit using the "Numeric Parameters" editing procedure
described on page 40.
Network Address
NOT E
The network addresses of devices in the same zone must be the
same.
The host address of the zone master is fixed at "2."
3 Link Mode
Shows the status of the [NETWORK] connector. The
[NETWORK] connector can be set to operate in "10Base-
T" or "100Base-TX" mode.
10Base-T: The [NETWORK] connector is compatible
with 10Base-T operation.
100Base-TX: The [NETWORK] connector is
compatible with 100Base-TX operation.
Edit using the "List Parameters" editing procedure
described on page 41.
4 MAC Adr.
This is the device's MAC (Media Access Control) address.
NOT E
The MAC address is also known as the Ethernet address, and is
an independent address assigned to all Ethernet devices. No two
devices anywhere in the world can have the same address.
Host Address
Display Setup (Disp) Page
Provides access to a number of display parameters.
N OTE
The meter fall time (3) is not shown on the ICP1 control panel
display.
1
2
3
1 LCD Contrast
The current LCD contrast setting. This parameter can be
adjusted from 0% through 100%.
Edit using the "Numeric Parameters" editing procedure
described on page 40.
2 LCD Backlight
Specifies LCD backlight operation. Two settings are
available: "ON," and "OFF."
ON: The display is continuously lit.
OFF: The display lights when a control is operated, and
will go out 10 seconds after panel operation ceases.
Edit using the "List Parameters" editing procedure
described on page 41.
3 Meter Fall Time
Determines the fall time of the level meters – "Fast" or
"Slow."
Fast: The meters rapidly follow changes in the signal
level.
Slow: The meters fall slower than the actual changes in
the signal level, allowing easier reading in some cases.
Edit using the "List Parameters" editing procedure
described on page 41.
DME64N/24N Owner's Manual
Utility Displays
49