AM
Antenna
Connections
Turn the loop until you have the
best reception.
Snap the tabs on the loop into the slols
of 1he base to assemble
the AM loop.
3
Notes:
• If the AM loop antenna wire is covered with vinyl, remove
the vinyl by twisting it as illustrated,
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord. This
could cause poor reception,
• ff reception is poor, connect an outdoor single vinyl-covered
wire
(not supplied) to the AM EXT terminal (Keep the AM loop antenna
connected,)
You can connect
the following
speakers:
• Two pairs of front speakers
to produce
normal s_ereo sound.
• One pair of surround
speakers
to enjoy the sun'ound
effect.
• One sun'ound
back speaker
or one pair of surround
back speakers
to enjoy to produce
more effective
surround
effect.
• One ccnler speaker
to emphasize
human
voices.
• One subwoofer
to enhance
the bass.
CAUTION:
Use only the speakers of the SPEAKER
IMPEDANCE
indicated by
the speaker terminals.
• When connecting
to both of the FRONT SPEAKERS
_1 and _2_
terminals,
use speakers with an impedance of 16 _ to 32 _.
• When connecting
to either the FRONT SPEAKERS
_1 or _z_
terminals,
use speakers with an impedance of 8 _ to 16 _.
Basic connecting
procedure
1
Twist and remove
the insulation
at
the end of each speaker signal cable
(not supplied).
2
Open the speaker
terminal.
RX-7030VBK/RX-7032VSL
(For FRONT SPEAKERS 2 terminals)
3
Insert the speaker signal cable.
4
Close the speaker
terminal.
For each speaker
(excepl
for a subwoofer),
connect
the (+) and
(-) lerminals
on the rear panel to the (+) and (-) terminals
marked
on the speakers.
Speaker laveut
Ideal speaker layout varies depending on 1he conditions of your
lislening room. The diagram below is a recommended typical
example.
Subwoofer
Left front speaker(s)
Center
speaker
Right front speaker(s)
(L)
(C)
(R)
Left surround
Right surround
speaker
(LS)
speaker
(RS)
Surround back speakers (LSB/RSB)
9