Frigidaire Gallery Series Owner's Manual page 23
Drop-in/slide-in model
Hide thumbs
Also See for Gallery Series:
- Owner's manual (44 pages) ,
- Use & care manual (34 pages) ,
- Installation instructions manual (25 pages)
Table of Contents
Advertisement
PROBLEM
POSSI BLE CAUSE / SOLUTION
GAS
BURNERS
COOKTOP
(some
models)
Surface burners do not light.
Surface control knob has not been completely turned to LITE.Pushin and turn the surface control
knob to LITE(until burner ignites) and then turn the surface control knob to the desired flame
size.
Burner ports are clogged. Clean burners. See "To Clean the Burner Grates, Contoured Burner
Pans, Burner Cap Assembly, Trim Ring and Burner Base" under General Cleaning. With the
burner off, use small-gauge wire or needle to clean ports or slots.
Electrical power outage (Electric Ignition models only), Check house lights to be sure. Call your
local electric company for service. Surface burners can be lit manually. See Setting Surface
Controls in this Owner's Guide.
Gas supply is turned off. Turn gas supply on.
Surface burner flame burns half
Burner ports or slots are clogged. With the burner off, clean by using a small-gauge wire or
way around,
needle to clean ports or slots.
Moisture is present after cleaning. Lightly fan the flame and allow the burner to operate until
flame is full. Dry the burners thoroughly following instructions under General Cleaning.
Surface burner flame is orange.
Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue.
Salt air in coastal areas. A slightly orange flame is unavoidable.
POOR
BAKING
RESULTS
Poor baking results.
Many factors affect baking results. Make sure the proper rack position is used. Center food in
the oven and space pans to allow air to circulate. Allow the oven to preheat to the set
temperature
before placing food in the oven. Try adjusting the recipe's recommended
temperature or baking time. If you feel the oven is too hot or cool, see Adjusting
Oven
Temperature
in the Electronic Oven Control section.
Flames inside the oven or smoking
from vent.
Excessivespillovers in oven. Set self-clean cycle for a longer cleaning time.
Excessivespillovers in oven. This is normal, especially for pie spillovers or large amounts of
grease on bottom of oven. Wipe up excessive spillovers before starting cycle. If flames or
excessive smoke are present, stop the self-clean cycle and follow steps under "To Stop or
Interrupt a Self-Cleaning Cycle" in the Electronic Oven Control section.
Avoid Service Checklist
23
Hide quick links:
Advertisement
Table of Contents
