Debugging Aggregator Operation
This section describes common troubleshooting procedures to use for error conditions that may arise
during Aggregator operation.
All interfaces on the Aggregator are operationally down
Symptom: All Aggregator interfaces are down.
Resolution: Ensure that port channel 128 is up and that the Aggregator-facing port channel on the
top-of-rack switch is correctly configured.
Steps to Take:
1. Verify that uplink port-channel 128 i s up (
display the status of member ports (
FTOS#show interfaces port-channel 128 brief
Codes: L - LACP Port-channel
LAG
L
128
FTOS#show uplink-state-group 1 detail
(Up): Interface up
Uplink State Group
Defer Timer
Upstream Interfaces
Downstream Interfaces : Te 0/1(Up) Te 0/2(Up) Te 0/3(Dwn) Te 0/4(Dwn) Te 0/5(Up)
2. Verify that the downstream port channel in the top-of-rack switch that connects to the Aggregator is
configured correctly.
244
|
Debugging and Diagnostics
Mode
Status
Uptime
L2L3
up
17:36:24
(Dwn): Interface down
: 1
: 10 sec
: Po 128(Up)
Te 0/6(Dwn) Te 0/7(Dwn) Te 0/8(Up) Te 0/9(Up) Te 0/10(Up)
Te 0/11(Dwn) Te 0/12(Dwn) Te 0/13(Up) Te 0/14(Dwn) Te 0/15(Up)
Te 0/16(Up) Te 0/17(Dwn) Te 0/18(Dwn) Te 0/19(Dwn) Te 0/20(Dwn)
Te 0/21(Dwn) Te 0/22(Dwn) Te 0/23(Dwn) Te 0/24(Dwn) Te 0/25(Dwn)
Te 0/26(Dwn) Te 0/27(Dwn) Te 0/28(Dwn) Te 0/29(Dwn) Te 0/30(Dwn)
Te 0/31(Dwn) Te 0/32(Dwn)
show interfaces port-channel 128 brief
show uplink-state-group 1 detail
Ports
Te 0/33
(Up)
Te 0/35
(Up)
Te 0/36
(Up)
Te 0/39
(Up)
Te 0/51
(Up)
Te 0/53
(Up)
Te 0/54
(Up)
Te 0/56
(Up)
(Dis): Interface disabled
Status: Enabled, Up
command) and
command).