Disabling The Projector's Buttons; Presenting Over A Wireless Network; Starting Easymp; Configuring The Connection - Epson PowerLite 765c Parts Manual
Epson multimedia projector product parts manual
Hide thumbs
Also See for PowerLite 765c:
- Product support bulletin (57 pages) ,
- Quick setup (2 pages) ,
- User manual (198 pages)
Table of Contents
Advertisement
Disabling the Projector's Buttons
When you enable the Operation Lock function, all the
projector's buttons are disabled except the P
This is useful, for example, if you want to prevent students in a
classroom from playing with the projector.
1. Press the
button.
Menu
2. Select the
menu and press
Setting
3. Select
and press
Operation Lock
4. Select
and press
ON
Enter
to confirm the setting.
5. Press the
button to exit the menu system.
Menu
Note:
You can cancel Operation Lock by pressing the projector's
button for 7 seconds.
Presenting Over a Wireless Network
Using EMP NS Connection, you can project images shown on
your computer screen directly to your audience without
connecting the projector to your computer. Before you begin,
make sure you've installed EMP NS Connection from the
CD-ROM that came with your projector. See the User's Guide
for installation instructions.
Starting EasyMP
Before you can connect to the projector wirelessly, you have to
switch it to EasyMP mode.
1. Turn on the remote control and the projector.
2. Press the
button on the remote control to select
EasyMP
EasyMP as the source.
3. Insert the Epson 802.11g/b card in the projector's card slot.
Make sure the label side is facing up.
Note:
Only the Epson 802.11g/b card is guaranteed to work. Other
cards may not be compatible. Replacement cards are available
only through an Epson authorized servicer.
button.
Power
.
Enter
.
Enter
. Then select
and press
Yes
Enter
Epson PowerLite 755c/765c Projector
4. Once the card is inserted, you see one of these screens,
depending on the currently selected mode:
Enter
Access Point mode
5. If you've already configured the projector for your wireless
network, go to "Projecting Wirelessly" on page 15.
Otherwise, continue with the next section.
Configuring the Connection
You must configure both the projector and your computer's
network settings to project wirelessly.
You can configure the projector for either of the following
modes:
Ad hoc mode (computer to computer): Lets you connect just
one computer at a time; you need a computer with a wireless
(802.11g or 802.11b) network card or adapter, or a Macintosh
with an AirPort or AirPort Extreme card.
Access point mode (infrastructure): Lets multiple computers
access the projector, or trade off control of the projector; you
need a wireless (802.11g or 802.11b) access point or an AirPort
(or AirPort Extreme) base station, and one or more computers
with wireless network cards or adapters.
1. Switch the projector to EasyMP mode and insert the Epson
802.11 g/b card.
2. When you see the EasyMP screen, press the
the remote control to select
3. Use the
Wireless LAN
8/05
®
.
Config
pointer button to highlight
, then press
.
Enter
Epson PowerLite 755c/765c Projector
Ad Hoc mode
button on
Enter
under
Basic
11
-
Advertisement
Table of Contents
