Operation; Problem Solving Steps; Obtaining Service - Bosch 5000 Series Use And Care Manual
Hide thumbs
Also See for 5000 Series:
- Use and care manual (64 pages) ,
- User manual (7 pages) ,
- Quick tips (2 pages)
Table of Contents
Advertisement
Self Help - Operation
Before calling for service, check the following:
Table 9: Self Help - Operation
Oven ProbNem
ProbNem SoMng
Steps
F03 or F04 Error appear in the
A problem with the lock occured. Turn power off and turn it back on again
display window,
after a few seconds. The oven should run a latch auto-test. If condition
persists, note the code number and call an authorized sewicer,
Other F
Error appears in the
Turn power off and turn it back on again after a few seconds. If condition
display window,
persists, note the code number and call an authorized sewicer,
Cooling fan continues to run
This is normal. The fan turns off automatically
when the electronic
after oven is turned off
components have cooled sufficiently.
Oven door is locked and will not
Turn the oven off at the circuit breaker and wait a few seconds. Turn breaker
release, even after cooling
back on. The oven should reset itself and will be operable.
Oven is not heating
Hake sure the oven temperature
has been selected.C beck the circuit
breaker or fuse box to your house. Hake sure there is proper electrical
power to the oven.
Oven is not cooking evenly
Check oven calibration. Adjust calibration if necessary (see Oven Offset,
Page !7). Refer to cooking charts for recommended rack position. Always
reduce recipe temperature by 25°F when baking with convention bake
mode.
Oven temperature
is too hot or
The oven thermostat
needs adjustment. See Calibrating Oven Temperature,
too cold
Page !7.
Oven light is not working
Replace or reinsert the light bulb if loose or defective. See Page 15. Touching
properly
the bulb with fingers may cause the bulb to burn out.
Oven light stays on
Oven light comes on automatically when oven begins heating.Press LIGHT to
turn oven light off. If oven is off, check for obstruction in oven door or check
to see if hinge is bent.
Cannot remove lens cover on
There may be soil build-up around the lens cover. Wipe lens cover area with
light
a clean dry towel prior to attempting to remove the lens cover,
Oven will not self=clean properly
Allow the oven to cool before running self=dean. Always wipe out loose soil
or heavy spill-over before running self<lean.
If oven is badly soiled, set
oven for a four=hour Self=Clean. See Self=Cleaning, Page 13.
Clock and timer are not
Hake sure there is proper electrical power to the oven. See the Clock and
working properly
Timer sections on Pages 2 and 8.
Excessive moisture
When using bake mode, preheat the oven first. Convection bake will
eliminate any moisture in oven (this is one of the advantages of convection).
Porcelain chips
When oven racks are removed and replaced, always tilt racks upward and do
not force them to avoid chipping the porcelain.
HOW TO OBTAIN
SERVICE
For authorized
service
or parts information
call 8OO/944o2904,
We want you to remain a satisfied customer, If a problem occurs that is not resolved to your satisfaction,
write to Bosch Customer Support, 5551 HcFadden Avenue, Huntington Beach CA, 92649 OFphone 800-944-
2904.
Please include the Hodel Number, Serial Number and date of original purchase and installation.
English • 19
Hide quick links:
Advertisement
Table of Contents
