Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document.
Safety information • Under no circumstances should you attempt In the interest of your safety and to ensure the to repair the machine yourself. Repairs car- correct use, before installing and first using the ried out by inexperienced persons will cause appliance, read this user manual carefully, in- injury or serious malfunctioning.
Installation or if the control panel, work top or plinth area are damaged such that the inside of the ap- • Check your dishwasher for any transport pliance is freely accessible. Contact your damage. Never connect a damaged ma- local Service Force centre, in order to avoid chine.
Control panel On/Off button Programme selection buttons Delay start button Indicator lights Function buttons Setting mode • Press On/Off button, ALL programme selec- tion button lights are illuminated = appliance IMPORTANT! in setting mode. Always remember that when performing opera- •...
Page 6
Function buttons In addition to the dishwashing programme selection, the following functions can also be set with the help of these buttons. – the setting of the water softener, – the cancelling of a programme in progress. Programme selection buttons •...
Page 7
Delay start button This option allows the start of the programme to be delayed by 3 or 6 hours. Before selecting the washing programme, press the On/Off button and then press the delay start button until the light corresponding to 3h or 6h illuminates.
Indicator lights Rinse aid Illuminates when rinse aid needs to be filled. 1) As soon as you select a washing programme, the phase indicator lights for that programme will start flashing. As the programme starts, the phase indicator lights turn off except for the indicator light of the phase in progress which will remain lit with a static light.
Programme Degree of soil Type of load Programme description Rinse and Hold Any. 1 cold rinse (to avoid food Partial load (to be completed later in the day). scraps from sticking together). This programme does not require the use of deter- gent.
Page 10
Water hardness Adjusting the water hardness Use of salt setting °dH °TH mmol/l manually electronically 51 - 70 91 - 125 9,1 - 12,5 level 10 43 - 50 76 - 90 7,6 - 8,9 level 9 37 - 42 65 - 75 6,5 - 7,5 level 8...
• The dishwasher must be switched off. • The End of programme light might flash 5 times, Switch on the dishwasher by pressing the On/Off for example. The flashing is repeated every 5 sec- button. onds. • Press and hold simultaneously function buttons B •...
IMPORTANT! Immediately start a complete programme. IMPORTANT! Water will overflow from the container as salt is added. Remove any trace of salt. Replace the cap tightly turning it clockwise until it stops with a click. IMPORTANT! Top up the special salt when the light on the control panel illuminates.
Adjusting the dosage of rinse aid Increase the dose if there are drops of water or Reduce the dose if there are whitish streaks on lime spots on the dishes after washing. the dishes or a bluish film on glassware or knife blades.
Page 14
For washing in the dishwasher the following cutlery and dishes are not suitable: are of limited suitability: • Cutlery with wooden, horn, china or mother-of- • Only wash stoneware in the dishwasher if it is pearls handles. specially marked as being dishwasher-safe by the manufacturer.
The two rows of prongs on the lower basket can be easily lowered to allow you to load pots, pans and bowls. Load upper basket. Light For taller items, the cup If plates are to be loaded in the upper basket: load items (plastic bowls etc.) racks can be folded up- them starting from the rear positions;...
To move to the higher position proceed as follows: 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards until the mecha- nism is engaged and the basket is stable. To lower the basket to the original position proceed as follows: 1.
For programmes with pre- When using detergent Close the lid. wash add an additional tablets: place detergent detergent dose in com- tablets in compartment A. partmentB. "3 in 1 function" This appliance is equipped with the "3 in 1 func- the indicator lights for salt and rinse aid are de- tion", that allows the use of the "3 in 1"...
function "indicator light illuminates. This means 4. To activate the rinse aid dispenser, press that the function is active. button B again, the end of programme in- To deactivate the function press the same but- dicator light illuminates, indicating that the tons again until the indicator light correspond- rinse aid dispenser has been activated.
Care and cleaning Cleaning the filters IMPORTANT! NEVER use the dishwasher without filters. In- correct repositioning and fitting of the filters will produce poor washing results. Clean filters A, B and C Turn the handle about 1/4 Remove filter A from the thoroughly under running turn anticlockwise and re- base of the washing com-...
use abrasive products, scouring pads or sol- Frost precautions vent (acetone, trichloroethylene etc..). Avoid placing the machine in a location where the temperature is below 0°C. If this is Internal cleaning unavoidable, empty the machine, close the ap- Ensure that the seals around the door, the de- pliance door, disconnect the water inlet pipe tergent and rinse aid dispensers are cleaned and empty it.
more detailed information about recycling of your household waste disposal service or the this product, please contact your local council, shop where you purchased the product. Something not working The dishwasher will not start or stops during Switch off the dishwasher, open the door and operation.
Page 22
Once these checks have been carried out; This information can be found on the rating close the dishwasher’s door and switch on the plate located on the side of the dishwasher appliance. Press the button of the programme door. that was running before the intervention of the So that you always have these numbers at hand, we recommend you to make a note of alarm.
Technical data Dimensions Width x Height x Depth (cm) 60,0 x 85,0 x 61,0 Electrical connection Information on the electrical connection is given on the rating plate on the Voltage - Overall power - Fuse inner edge of the dishwasher’s door. Water supply pressure Minimum - Maximum 0,05 - 0,8...
Test in accordance with EN 50242 must be rinse aid respectively and using the test pro- carried out when the salt container and rinse gramme (see "Consumption values"). aid dispenser have been filled with salt and Full load: 12 standard place settings Amount of detergent required 5 g + 25 g (Type B) Rinse aid setting...
you should run the water for a few minutes be- WARNING! fore connecting the inlet hose. Only use, for connection to the water mains, new hose-set; old hose-set must not be reused. CAUTION! If the machine is connected to new pipes or pipes which have not been used for a long time, Inlet hose Connect the inlet hose to a water tap with an external...
If you use a drain hose extension the total This could constitute a fire hazard through over- length should not be longer than 4 metres. heating. Likewise the internal diameter of the couplings If necessary, have the domestic wiring system used for connections to the waste outlet must socket replaced.
Levelling Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on either side of the cabinet. Guarantee/Customer Service use for professional or equivalent purpo- Belgium ses. DECLARATION OF GUARANTEE TERMS.
Page 28
The statutory warranty does not apply disproportionate, in agreement with the when defects are caused by: consumer, the defective appliance may be replaced with another appliance of the – a chemical or electrochemical reaction same value. In this event, we reserve the caused by water, right to ask for a financial contribution cal- –...