Canon VB150 User Manual page 39

Network camera server guide to creating web pages for video distribution

Hide thumbs Also See for VB150:

Table of Contents

Remote Firmware Upgrade-related Log Messages

●I001 Remote firmware upgrade write error (err)

cannot reboot as the firmware is broken

Message

Explanation

Reboot cannot take place because there is an error in the firmware that was written

onto read-only memory during the firmware remote upgrade. This error is not a transfer

error and has not occurred as a result of a break in transfer. This type of error occurs

only when firmware is erased from the ROM or when firmware is written onto the ROM.

Response

Contact your local Canon service representative. There is a possibility that the flash

ROM chip has been damaged.

●I002 Application program is stopped because of the remote firmware upgrade (info)

Message

application is halted for updating the firmware

Explanation

The application program has been stopped so that the firmware can be installed

remotely. All operations for WebView, picture recording and external device output

control that are underway will be discontinued, and new commands will not be

accepted until a reboot has been carried out.

●I003 Remote firmware upgrade completed (info)

firmware is updated

Message

The remote firmware upgrade process has been completed.

Explanation

●I004 Reboot due to remote firmware upgrade timeout (warnning)

reboot as the firmware update time is out

Message

Explanation

The VB150 restarted due to firmware remote installer timeout. This happens when

communication with the installer has been cut for 5 minutes due to network error etc.

Response

Check to be sure that the camera server has been restarted. (Refer to the version

and revision numbers that are displayed at the top of the settings title page and

check that the numbers are that of previous version firmware).

Log Messages

Table of Contents