Table of Contents
Advertisement
Setup Menu (Basic tab)
In the setup menus you may adjust your camera's operating environment. The settings
will be retained after the power has been turned off or Auto Power Off is activated.
1. Slide the mode switch to [ ] and set the mode dial to [
The [Basic] tab of the set-up menu is displayed.
2. Select the desired [Basic] option item with the
buttons, and press the SET button to enter its
respective menu.
3. Select the desired setting with the
and press the SET button.
4. To exit from the set-up menu, change the mode dial setting.
Card Info.
This will display the total capacity of your memory card as well as the remaining (unused)
capacity. Note that the stated capacity may be less than the advertised (labeled)
capacity of your SD memory card. This is attributable to the difference between binary
(base 2) and engineering (base 10) methods of capacity calculation.
Fr. No. Reset
This creates a new folder on your memory card. From this point forward, newly captured
images are stored in the newly created folder starting with image number 0001.
* Cancel / Execute
Format
This function reformats the SD card loaded in your camera and thereby erases all images
as well as any other non-image data on the memory card. Even protected images are. An
SD card cannot be formatted if it is write-protected.
Refer to the section in this manual titled "Formatting an SD Card" for further details.
Beep
Enables or disables the sounds (beeps) associated with camera button functions.
* On / Off
Auto Off
If no operation is performed for a specific period of time, the camera will automatically
turn off. This feature is useful to reduce battery consumption.
* 1 Min. / 2 Min. / 3 Min. / Off
USB
This sets USB mode when connecting to your computer at any camera mode.
* PC / PictBridge
EN-52
].
/
/
buttons,
USB
PC
Advertisement
Table of Contents
