Windows 2000 Driver Installation; Overview; Installing The Driver - HP LC2000r - NetServer - 128 MB RAM Manual

Fibre channel host bus adapter

Hide thumbs Also See for LC2000r - NetServer - 128 MB RAM:

Table of Contents

Windows 2000 Driver Installation

NOTE

Check this worldwide web address to ensure that you have the latest

version of the Windows 2000 driver:

http://netserver.hp.com/netserver/

If it is a newer version than the one on the supplied HP Navigator CD,

download it and use it instead of the earlier driver.

Before installing the Fibre Channel Adapter driver, the Windows 2000 system

should be up and running.

The HP Navigator CD contains the fibre channel HBA drivers. You need to

create a driver diskette before driver installation. Follow these procedures to

create driver diskette:

• Insert the HP Navigator CD into the HP Netserver CD ROM drive, and

boot the Netserver with the CD.

• On the main menu, select Netserver utilities, then select diskette

library.

• Select the "HP D8602B Fibre Channel HBA Win2K support disk".

• Insert a diskette into the floppy disk drive.

• Follow instructions on the screen to create driver diskette.

The AFCW2K.SYS miniport driver installation is done through the standard

Windows 2000 PnP driver installation. Miniport driver installation can be done

multiple ways: using the Windows 2000 PnP hardware detection, Hardware

Wizard, Device Manager, etc.

Follow the instruction indicated by Windows 2000 "Found New Hardware"

Wizard and specify "Floppy disk drive" when selecting the search location for

the driver.

Table of Contents