HP D7171A - NetServer - LPr Installation Manual page 31

Compaq 4000/ 7000 series racks installation guide

Hide thumbs Also See for D7171A - NetServer - LPr:

Table of Contents

Chapter 3

Rear of HP NetServer

Left Rear

Rack Column

Figure 3-16. Attaching the Cable Management Arm

5. Attach the other flange of the cable arm to the rear column of the rack

with the two M6 screws, included with the non-HP rack kit.

6. Attach the flange to the NetServer with the two 2-32 pan head Torx T-20

screws, included with the Arm. See Figure 3-16.

7. Extend the NetServer out of the rack to ensure the Cable Management

Arm moves along with the chassis without binding.

NOTE

Refer to the HP NetServer LC 2000r Rack Cabling Reference

Guide, for information about cable dressing and routing.

8. If the Cable Management Arm moves with the chassis and the rack

installation appears to be successful, slide the NetServer into the rack.

The NetServer should click into the latches on the two column adapters.

9. If the NetServer is not in a restricted-access area, tighten both slide

securing screws on the bezel latching mechanisms. See Figure 3-16.

Rack-Mounting the HP NetServer

Cable Management Arm

Table of Contents