Removing A Hot Plug Board - HP D7171A - NetServer - LPr User Manual

Pci hot plug utility

Hide thumbs Also See for D7171A - NetServer - LPr:

Table of Contents

Chapter 1

6. If the left P (Power) LED is turned off (gray), go to the next section,

"Removing a Hot Plug Board" to remove the PCI Hot Plug board.

Removing a Hot Plug Board

Use this topic to physically remove a PCI Hot Plug Board from the slot.

1. At the front of the NetServer, remove the front bezel from the HP

NetServer (refer to your Installation Guide).

2. Extend the HP NetServer chassis safely from the rack (refer to your

Installation Guide).

3. Remove the PCI Access Panel (refer to your Installation Guide).

CAUTION

Do not drop screws or other metal objects into the HP

NetServer.

4. Verify power to the desired PCI slot is turned off, by checking the desired

PCI slot's Power LED (right) on the rear panel is off (gray).

The right green Power LED must be OFF. See Figure 7 and Table 1.

5. If not, go back to the section "Powering Down a PCI Slot" and verify you

have turned off power to the correct slot.

6. If you are unable to power down the slot, remove and install the PCI board

in the PCI slot as described in the Installation Guide.

CAUTION

To prevent a possible system crash or hang do not continue

with this procedure if you are unable to turn off power to the

PCI slot.

Server Administration Using HP TopTools

Table of Contents