Configuring System Settings; Changing The System Date And Time; Changing Host Interface Settings - HP P2000 Reference Manual
Msa system
Hide thumbs
Also See for P2000:
- Reference manual (448 pages) ,
- Deployment manual (74 pages) ,
- Release note (18 pages)
Table of Contents
Advertisement
Configuring system settings
Changing the system date and time
You can enter values manually for the system date and time, or you can set the system to use NTP as
explained in
About the system date and time
Time (UTC).
To use manual date and time settings
1.
In the Configuration View panel, right-click the system and select Configuration > System Settings >
Date, Time. The date and time options appear.
2.
Set the options:
• Time. Enter the time in the format hh:mm:ss, where hh is the hour (0–23), mm is the minutes (0–59),
and ss is the seconds (0–59).
• Month.
• Day.
• Year. Enter the year using four digits.
• Network Time Protocol (NTP). Select Disabled.
3.
Click Apply.
To obtain the date and time from an NTP server
1.
In the Configuration View panel, right-click the system and select Configuration > System Settings >
Date, Time. The date and time options appear.
2.
Set the options:
• Network Time Protocol (NTP). Select Enabled.
• NTP Time Zone Offset. Optional. The system's time zone as an offset in hours, and optionally
minutes, from UTC. For example: the Pacific Time Zone offset is -8 during Pacific Standard Time or -7
during Pacific Daylight Time; the offset for Bangalore, India is +5:30.
• NTP Server Address. Optional. If the system should retrieve time values from a specific NTP server,
enter the address of an NTP server. If no IP server address is set, the system listens for time messages
sent by an NTP server in broadcast mode.
3.
Click Apply.
Changing host interface settings
To enable the system to communicate with hosts or with remote systems, you must configure the system's
host-interface options. There are options for FC and iSCSI ports but not for SAS ports.
To change FC host interface settings
1.
In the Configuration View panel, right-click the system and select Configuration > System Settings >
Host Interfaces.
2.
Set the speed to the proper value to communicate with the host. Speed can be set to auto (the default),
which auto-negotiates the proper link speed with the host, or to 8Gb (Gbit per second), 4Gb, or 2Gb.
Because a speed mismatch prevents communication between the port and host, set a speed only if you
need to force the port to use a known speed for testing, or you need to specify a mutually supported
speed for more than two FC devices connected in an arbitrated loop.
3.
Set the connection mode to loop, point-to-point, or auto (the default). Loop protocol can be used in a
physical loop or in a direct physical connection between two devices. Point-to-point protocol can only
be used on a direct physical connection between exactly two devices. Auto sets the mode based on the
detected connection type.
4.
Set the loop ID for each controller to request when the controller arbitrates during a LIP. A controller can
use soft or hard target addressing:
• Soft target addressing, which is the default, enables a LIP (loop initialization process) to determine
the loop ID. Use this setting if the loop ID is permitted to change after a LIP or power cycle. To use
this option, select Soft?.
44
Configuring the system
on page 32. Date and time values use Coordinated Universal
Advertisement
Table of Contents
