Table of Contents
Advertisement
2.5.5
APM Configuration
Power Management/APM
Restore on AC Power Loss
Advanced Resume Events Controls
Resume On Ring
Resume On LAN
Resume On PME#
Resume On KB
Wake-Up Key
Resume On PS/2 Mouse
Resume On RTC Alarm
Power Management/APM [Enabled]
Allows you to enable to disable the Power Management/APM function.
Configuration options: [Disabled] [Enabled]
Restore on AC Power Loss [Last State]
When set to Power Off, the system goes into off state after an AC power
loss. When set to Power On, the system goes on after an AC power loss.
When set to Last State, the system goes into either off or on state,
whatever the system state was before the AC power loss.
Configuration options: [Power Off] [Power On] [Last State]
Resume On Ring [Disabled]
When set to [Enabled], the system enables the RI to generate a wake
event while the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
Resume On LAN [Disabled]
When set to [Enabled], this parameter allows you to turn on the system
through a PCI LAN or modem card. This feature requires an ATX power
supply that provides at least 1A on the +5VSB lead.
Configuration options: [Disabled] [Enabled]
Resume On PME# [Disabled]
When set to [Enabled], the system enables the PME to generate a wake
event while the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
2-30
[Enabled]
[Last State]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Any Key]
[Disabled]
[Disabled]
Configure CPU.
Select Screen
Select Item
Enter Go to Sub-screen
F1
General Help
F10
Save and Exit
ESC
Exit
Chapter 2: BIOS setup
Hide quick links:
Advertisement
Table of Contents
